Senior Resident, Department of Dentistry, Shri Krishna Medical College and Hospital, Muzaffarpur, Bihar, India

MDS, Prosthodontic clinic, Buxor, Bihar, India.
Lucitone 199 ,Lucitone FRS ,Acrylic denture base resin ,Polyamide (Nylon) denture ,

Aim &Objective: The objective of this study was to evaluate and compare surface hardness of compression molded heat cure acrylic denture base resin and polyamide (Nylon) denture base material. Materials and method: Two denture base materials lucitone 199 (compression molded heat cure acrylic denture base resin) and lucitone FRS (polyamide (nylon) denture base material) were used for evaluating and comparing surface hardness. Metal dies of dimensions 65mm x 10mm x 3mm were fabricated which was invested to prepare heat cure acrylic denture base resin specimens by compression moulding technique and injection moulding technique is used to make specimens of polyamide (lucitone FRS) specimens under strict quality control. Thus total 20 specimens were fabricated, with 10 specimens of each type of denture base material. These specimens were stored in artificial saliva at 37oC in an incubator (Thermolab, B.O.D. Incubator, Sterling chambers, Mumbai) for 7 days. Testing of specimens for surface hardness was done. Result: Within the limitations of this study it was concluded that Compression molded heat cure acrylic denture base resin (Lucitone 199) showed higher surface hardness when compared to Polyamide denture base material (Lucitone FRS) and this difference was statistically significant (p < 0.05).

9 , 1 , 2019